额定值

n.rating; rated value; nominal value

网络释义：rating value; NOMINAL; Ratings

网络释义

n.1.rating2.rated value3.nominal value4.excursion1.rating2.rated value3.nominal value4.excursion

1.rating ratemeter 定率计 rating 额定值 ray 光线  ...

2.rated value rated condition 额定工况 rated value 额定值 short-time duty 短时工作制 ...

3.rating value 胶类型（ Resist） 额定值（ Nominal） 均匀性（ Uniformity） ...

5.nominal value 额定输入电压 NOMINAL INPUT 额定值 NOMINAL VALUE 离线 OFF LINE ...

6.Ratings rating 定额 ratings 额定值 ratio analysis 比率分析法 ...

7.nominal rating nominal power 额定功率 nominal rating 额定值 nominal size 公称规格 ...

8.DFR在对细节疲劳额定值(DFR)方法深入研究的基础上,对 MA700飞机机身蒙皮典型对接结构进行了疲劳寿命分析,确定了该结构的载 …

1.The voltage rating of these resistors must be at least equal to the test voltage.这些电阻器的电压额定值必须至少等于测试电压。

2.This is not usually specified for a switch card, but the limitation is usually a function of the trace width and connector ratings .虽然开关卡的技术指标并不明确显示，但是电流限值通常是走线宽度和连接器额定值的函数。

3.If the insulation is to be as well protected after it is reduced, the arrester rating must be correspondingly reduced.若绝缘减少后仍同样地能被保护，那末避雷器额定值也必须相应降低。

4.Do not exceed the speed in revolutions per minute (RPM) rating of any grinding wheel or disk.不可超过任何砂轮片或转盘的每分钟转数（RPM）额定值。

5.ASME capacities are steam pressure ratings and do not reflect the CSA temperature relieving capacity of the valves for selection purposes.ASME流容是蒸汽压力额定值，并不代表阀门在所选择的用途中CSA温度泄放能力。

6.Nameplate rating is only a guide to transformer application, and should only be used as a first step in the selection process.铭牌额定值仅是变压器应用的一个指导，只是选择过程的第一步。

7.When electric power coupling transformer at input current is less than rated value, public winding can be also overload.电力自耦变压器在其输入电流均小于额定值时，其公共绕组也可能过负荷。

8.Ratings are in accordance with the recommended standards adopted by the Steam Heating Equipment Manufacturers Association.额定值符合美国蒸汽加热设备制造商协会所采用的推荐标准。

9.Be sure to use capacitors within the specified values by checking the voltage waveform, current waveform, and frequency applied to them.使用前请先检查电容器两端的电压波形、电流波形和频率是否在额定值内。

10.When the air pressure of the inner tube rises to a rated value, the one-way valve is closed, and the inflation process is completed.内胎气压升高到额定值时，单向阀关闭，充气过程即结束。